Extended bars?

[baxt3r]

Bought some extended 0 degree bars from Blowsion. When they arrived I was a little surprised at how much longer they are. Does anyone ever cut these down or is the extra length something I might come to like?

What size hole is required for the throttle screw on a 91 SuperJet? I've got to drill one, but I'd prefer to not overdo it.


Thanks.

 

[Matt_E]

I run 28 inch bars....a bit wider than normal, but you get used to it.

 

[Big Kahuna]

Wide Bars = Leverage.

Place the throttle at the angle you want then tape the throttle so it does not move. (install grips also so you get it in the right place). You can use a tad smaller drill bit and then use the screw to actually tap the threads.

 

[mademan9]

Got mine thru Xmetal. It was weird at first , but i love'em now

 

[baxt3r]

I was a bit worried about the width on my RXP when I had the throttle conversion done. It took a few minutes to get used to but I like it. Hopefully this will work out the same.


Thanks for the tip Kahuna.