Polish jet pilot
4aces4aces4aces4aces4aces
- Location
- Warsaw, Poland
I told ya he makes great stuff!! Hi Maris! I want my hull 
Defoamig an OEM RN hull
- Thread starter Polish jet pilot
- Start date
i ride defoamed and i noticed a huge difference. the foam gets wet and will get regardless oh how well you seal. I defoamed, reinforced like a mother#$%& and put a drain plug. i then stuck a hose into the drain plug and under pressure filled the back till the water started spraying out of a few places where it was taking in water. sealer them and now its really good. a barely get any water after a full day of riding. just dont forget to close that drain plug:bananajump:
- Location
- St.catharines, Ontario
how long is that air going to stay in when you ski is full of water and your and you in the middle of the water and its sinking
Polish jet pilot
4aces4aces4aces4aces4aces
- Location
- Warsaw, Poland
Anybody has a pic of a drain plug setup? Pump area or rear ?
Freakrider
X247
- Location
- Tampa Bay area
Freakrider
X247
- Location
- Tampa Bay area
if it is sealed good it will float a long time.....super-ski has zero water in his tray hull when he pulls the drain plug after riding all day.
Last edited:
Mark44
Katie's Boss
- Location
- 100% one place
Polish jet pilot
4aces4aces4aces4aces4aces
- Location
- Warsaw, Poland
Mark44, great pic! Thanks! So how does a drain plug look like (anything specific) or I can insert an inside threaded hull insert (expandable) and just screw in some type of screw... :jester:
Polish jet pilot
4aces4aces4aces4aces4aces
- Location
- Warsaw, Poland
Never mind that, I think I will use couch plugs - but still those metal ones you showed are nice - close up pic?