SXR Cylinder head water fittings

[XFT LOU]

The factory pipe instructions call for ;

1/8 BSP x 3/8 barb.
To be installed in the OEM head s existing outlet holes after removing the stock fitting.

Is this parallel or taper ?

Where can you purchase the correct size ?
Straight and 90 degree elbow .

Thanks

 

[kx454]

Wet or dry pipe? I've got a dry here I'd be glad to measure up whatever you need

 

[XFT LOU]

It's the fitting on the cyl. Head .

 

[kx454]

Stock or aftermarket head? Either way I believe it is taper, I ended up running a straight fitting for my setup....less of a bend was needed on the for the cooling line

 

[TheBuzzard]

the fitting that comes with the new dry pipe is a straight fitting. its stainless steel and does flow more water than a brass fitting since the wall is thinner. i used to use 90 fittings cause they cleared the pipe better. i had dual cooling from the pump. one cooling the motor and one for the pipe.dual head outlets went to pissers.