650/X-2 Cutting info

[UKUnicorn]

Hey everyone,
Hope you are doing great,
So i have another X2 hull cutting question, im looking at shaving the seat right down to a flat deck, but im curious as to is it as simple as shave it off and fibreglass it up or is there some interworkings going on in there i need to be aware of (i noticed drainage holes but thats about it).
Many thanks guys

 

[FTW FreeStyle]

Mine is flattttttt asf I cut mine past the drain holes flush with the top of the pump cavity I am litterally standing on the pump basicly get a sawzall an start from the rear hack off a couple inches off the seat compartment till you reach the pump cavity remove foam then straight edge the line and make final cut as straight as possible get 2 cans of foam refill any area as needed let fully dry and cure grab 6 sheet of fiberglass and Bondo from home depot they have 3m brand best stuff for fiberglass work then start laying sheets of fiberglass or 4 pieces of 3 mill strand from any fiberglass shop and lay the fiberglass in layers sand and repeat untill final layer then sand again and final resin coat then glaze and prime and paint easy mod

 

[FTW FreeStyle]

Yup simple

 

[UKUnicorn]

Mine is flattttttt asf I cut mine past the drain holes flush with the top of the pump cavity I am litterally standing on the pump basicly get a sawzall an start from the rear hack off a couple inches off the seat compartment till you reach the pump cavity remove foam then straight edge the line and make final cut as straight as possible get 2 cans of foam refill any area as needed let fully dry and cure grab 6 sheet of fiberglass and Bondo from home depot they have 3m brand best stuff for fiberglass work then start laying sheets of fiberglass or 4 pieces of 3 mill strand from any fiberglass shop and lay the fiberglass in layers sand and repeat untill final layer then sand again and final resin coat then glaze and prime and paint easy mod

Sweet this is exactly what i was looking for, many thanks Man