New Crank works 4 mill stroker crank Kawasaki

[Octane_114]

It is a new crank, it was a spare that did not get used.

1000.00 bucks

 

[Sober750X2]

What pistons would you run with these? Just any forged piston?

 

[MTRHEAD]

Are those 135mm GPR size hot rods?

 

[Octane_114]

they are hot rods. only one’s available at the time

 

[Octane_114]

What pistons would you run with these? Just any forged piston?

I have always used wiseco pistons.

 

[Octane_114]

What pistons would you run with these? Just any forged piston?

You can use the piston brand of your choice. My pistons start at 85mm on one engine and 89mm on the second engine.

 

[MTRHEAD]

they are hot rods. only one’s available at the time

Do you know if they are 135mm GPR or 133mm Kaw versions? Many cranks were made with either. Most over 77mm stroke got the GPR rods but can’t tell from your picture

 

[Octane_114]

I’m almost positive they are the 133 Kawasaki hot rods. I will check later this afternoon.

 

[Octane_114]

Do you know if they are 135mm GPR or 133mm Kaw versions? Many cranks were made with either. Most over 77mm stroke got the GPR rods but can’t tell from your picture

 

[Sober750X2]

Do you have to do anything to the cylinders or need a thick base gasket or anything to run this?

 

[Octane_114]

Do you have to do anything to the cylinders or need a thick base gasket or anything to run this?

You have to set the engine up properly. Cases need trenching along with some porting. I had shims/spacers cut vs using thicker gaskets. It’s how you want your engine built. You can’t drop this crank in a set of stock 800 cases and go. It won’t make a full revolution.