Yohns Kustom Fabrikation
Pushing The Limits
- Location
- Bushnell, Fl
Bought a 760 cylinder that was cracked around the exhaust port. Used the oven to get the sleeves loose (old lady is far from happy lol) and one dropped out and one went halfway and stuck. the crack made a bur in the cylinder and i had to beat it out with a punch and hammer. Naturally it made a little gouge in the cylinder wall as it came out. Will it be a problem if i clean it up/ smooth it around the scrape before putting in the new sleeves ir is it going to be a problem? Really hope this jug isnt trash now.