SXR cold water vs wet pipe tunning

[gaby7mm]

does the cold water affect the tunning of my wet pipe?the pipe dont want to sizzle.botom 1/2 middle close and top 1/2.

 

[LegDragger64]

I don't run them so hot they sizzle. Next thing you know you will cook all your hoses and hose lamps will come loose. I just find the point at which it oes sizzle and then open the screw some . How far to open screws all depends on water temps and how your lines are routed . If you have a separate c old water line straight from pump , it takes less to cool pipe . Also depends on water pressure. Every ski is different.

 

[gaby7mm]

the waterline are routed the same way factory pipe says,i buy the pipe used,the middle screw was open a bit when i buy it,i closed him to try to make it sizzle but do nothing,what the middle screw does?

 

[fastgtfairlane]

try going to 1/4 turn for each screw and see if it drys it out a lil more.. you only want the first two or so inches of the chamber to sizzle

 

[TITAN]

I got mine dialed in and it never sizzles.

 

[sxrmike420]

Mine sizzles like your frying an egg

 

[Octane_114]

mine is dialed in and it does not sizzle... but i run my pipe for the most bottom end. top screw open 2turns, middle and bottom screw closed.

i was wondering the same thing on the water temperature.

 

[fastgtfairlane]

im pretty sure depending on what screws you open will determine where the hit comes in but drying it out enough to where it barely sizzles will get the most power out of the pipe without a decrease in bottom end.. you will jsut pick up a few rpms on the top