- Location
- Plano, TX
So, I'm about to start jetting/tuning my carbs after doing quite a few mods over the winter, and I wanted to see if anyone could help me out with some good starting points. Here are the mods...
ADA Billet Head (28cc) 165ish PSI (I haven't checked the compression yet, the engine is still in pieces)
Dual Cooling Mod
Vforce 3 Reeds with ADA spacers
Dual 46mm SBNs (w/ two fuel pumps and two pulse lines)
R&D intake bored out to match the carbs
Factory Dry Pipe with ECWI
Thanks in advance!
- Marc
ADA Billet Head (28cc) 165ish PSI (I haven't checked the compression yet, the engine is still in pieces)
Dual Cooling Mod
Vforce 3 Reeds with ADA spacers
Dual 46mm SBNs (w/ two fuel pumps and two pulse lines)
R&D intake bored out to match the carbs
Factory Dry Pipe with ECWI
Thanks in advance!
- Marc
Last edited: