Super Jet blowsion aftermarket pole spring question

[SkiDiggity]

So either it is impossible unless someone can prove me wrong. I can't get the aftermarket pole spring to work with my Rn pole conversion. it fits into the holes but sits at an angle that is impossible to get it to come back to the way it needs to to get the pole bolt in.

Anyone have any suggestions or helpful tips along with pictures? if so that would be great because this is retarded.

 

[camojoe]

I use one as well. You are suppossed to heat it and bend it to whichever angle you want.

 

[mybad]

i just installed a Riva spring in my RN. I didnt keep the directions but I definately remember a reference to cutting a portion of the spring when used in an aftermarket mount. And BTW the spring was crooked on my stock setup until I smacked the bolt with a hammer. try suspending the handle pole from above. it really makes it easier.

 

[SkiDiggity]

yeah i got it on after heating it bending it using a tie down, pry bar, dead blow, and my 7 foot neighbor hahah just hope this pole does not break.