Blaster barrel roll????HELP

jetskier79

jetskier79

I'm goin' for two
Location
San Diego, CA
You're definitely going to break some fiberglass in the learning process. Make sure your hood is latched down tight and you'll be less likely to break the lip of the hood that sits down in the seal.

When you go for the roll - commit to it!

All good advice in this thread...well, except this one..

WaveDemon said:
bailing on rolls is not that big of a deal. the rotation throws you away from the ski.
Click to expand...

Don't bail, just simply don't do it. Hold on and ride it out, even if your laying on the underside of a flopping blaster. NORMALLY a roll will separate you from the ski, but there are plenty of cases where it will not, and the consequences are about the most dangerous there are in jetskiing.

I'll contribute a couple videos as well. Ahh the good ol' days.

My first rolls

My worst crash resulting from rolls
 
Last edited by a moderator:
diamondaudio10

diamondaudio10

Wave Junkies
Location
Virginia Beach, Virginia, United States
yeah dont let go, ive bout had my dome takin off bailin on a roll, zimmy worked with me on it. you have to cut it the opposite way u wanna roll and then the way u want to. get on the gas, make sure ur feet are tight in the straps, and lean all the way right after u cut it back to the way ur rollin. lean hard to the side dont lean foward during the roll or it slows u down and u usually end up upside down. dont forget to hold on!
 
You must log in or register to reply here.
Top Bottom