Blaster Blaster 1 group k hammer 96 jetting

[MADDMATT]

Just got my carbs back from group k today.
they were to be taper bored and jetted for my 96 b1 with b pipe limited and hammer 96 kit.
i opened them up to check what jets were used and found the following.

1.5 n/s
75 low
150 high Pop off has not been checked yet....

Does this seem like the proper jetting for this setup???

 

[Philip Clemmons]

Never had an issue with any of their stuff. My 633 hammer 93 ran 52 on radar with a single 46 and their jetting.
They like smaller pilots and needle and seats. Doesn't seem wrong. Harry is great about quick email responses if you include something like "help with motor just purchased from you" in the title.