- Location
- amarillo ,tx
my dam bilge pumps keep running after switch is turned off, would the switch b the first thing to check out, or could i have a short in the wires somewhere else.
Super Jet bilge pumps keep running after switch is turned off.
- Thread starter txsuperjetfreak96
- Start date
- Location
- greenville, nc
its the switch
SJBrit
Extraordinary Alien
- Location
- Bradenton, FL
Sounds like a switch problem. Or it's haunted.
- Location
- amarillo ,tx
its weird cuz i can pull the fuse and put it back in and itll work fine for a while then itll do it again,
Definitely the switch. Corrosion and water will make those things act real funny. Just replace it if you need the switch. I run my bilge 100% of the time so I just connect the fuse before I ride and leave it but even then I have to replace the fuse every few months because they corrode as well and make wierd contact.
- Location
- Houston/Galveston
Get with SXIPRO for one of his bilge switches.
Midlake Crisis
Site Supporter
- Location
- Bakersfield, CA
I had that problem with my handlebar mounted switch. I went to one of the military/marine grade toggles. So far so good.
Boris
The Good Old Days
- Location
- The surf-less coast
Best switch ever and the only one that has lasted on my ski. I have tried them all but the salt kills them in no time except this one.
The Penguin
triple secret probation
- Location
- down by the river
it's haunted, call Tangina
Midlake Crisis
Site Supporter
- Location
- Bakersfield, CA
I would turn my old switch off and it would turn on by itself in the middle of the night out in the garage.
... and the ski would stare in my face... and she would ask if we are going for a ride right now...
- Location
- amarillo ,tx
i gotta replace one of my rules, its like 5 yrs old, the casing looks to be warped, it works fine if u hold it upside down then if u put it like it suppose to b the fan snags on the plastic piece, its like the whole assembly inside drops down no biggie.