Bilge pump mounting???

[theRabbitbutton]

I'm new to my 750 sx I picked up last summer and wanted to install a bilge as the usual...

My question is....how are you guys mounting this in the ski? I want a bracket for my bilge but wondering where it bolts too? Pictures sure would help...Thank you for your input...

 

[N3vrSat1sfied]

bolts to intermediate housing (where driveshaft goes through the bulk head)

Or you can use plastic welder epoxy and glue it down.

 

[theRabbitbutton]

Wow thanks...sounds good. Is there a bilge pump that specifically fits on that mount or any recommendations?

 

[N3vrSat1sfied]

Wow thanks...sounds good. Is there a bilge pump that specifically fits on that mount or any recommendations?

any of the round Rule brand that look like this:

Most people run the 360 GPH or the 500 GPH. There are several sellers on this site that will have them in stock.

 

[theRabbitbutton]

Thank you...great forum to be a part of. I will check the vendors out...

 

[sxipro02]

I prefer the 360 bc it will pull the water level lower without cavitating as bad as the 500. I run a 360 and 500, the 500 always shuts off first. I epoxy mine down to the hull as close to the back as I can. Be very careful when picking a place for your bilge to dump, I drilled my holes when I had stock exhaust and now have to use 90deg fittings with a AM exhaust. Also put the hole high on the hull so it wont take on water when sitting in the water.

 

[sxipro02]

And welcome to the X, It is loaded with cool people and tons of useful info.

 

[theRabbitbutton]

yes definitely thank you for the response...this is a cool place for info and news in the stand up world.

 

[Sxirider44]

Yeah definitely the outlet high I don't think people realize when are on your knees for a little or riding slow and the bildge outlet is under the water line it takes water in .i have mine siliconed behind my battery on my 750 but I'd recommend epoxy