Super Jet B pipe mani bolts

[danimal365]

I'm trying to put a b pipe on my 64x in a superjet. I don't think i have the right bolts from the stock b2 exhaust. I know they are M10, but what is the length i need to get? It figures i'm doing this on a friday night and probably don't have access to the bolts till monday morning.

 

[Al//gsx//sj]

the 3 bolts for the headpipe are M10x1.25x40mm long. zinc coated head bolts (and standard/regular head) should be easy to find at a local hardware store. SS are special order from a nut/bolt supply house. (or Chris sells a SS allen head set w/washers). not sure about the 8 bolts for the manifold, M8's?

 

[danimal365]

I have the 3 bolts for the headpipe, i just need the 8 bolts for the manifold. I know on the 61x they are m8's and the 62t/64x are m10, but i don't know what length...

 

[QJS]

If you use the same length as the original M8's they should be fine. If you struggle to get hold of these, M8 helicoils will screw straight in then you can use the original M8 bolts.
Chris.

 

[danimal365]

I pulled my motor out of a blaster 2, so the bolts i have are super long. I can just run to fastenal, but i need the length. Any ideas?

 

[danimal365]

I googled everywhere, went to 2 supply houses and Fastenal was able to order them for 22 each. NO I didn't get them. I will just do the helicoil m8 trick....

 

[nightrider05]

I used helicoils to install a 61x manifold on a 62t cylinder and they have held up great...been pulled apart a few times and retorqued without any issues at all.