any imput on this bilge pump

[2006superjet]

http://us.binnacle.com/product_info.php?products_id=2462


any imput. anyone ever used this says it picks up to 10mm of water.
i think my current one leaves at least and inch.

 

[SuperJETT]

Interesting, I like it. A little pricey, I wonder if it can run dry and not burn up?

 

[Shifty]

Back when there were bilge pump championships going on it got mentioned, but no one tried it.

 

[YAMA CAT]

http://www.westmarine.com/webapp/wc...6?&cid=chanintel&ci_src=14110944&ci_sku=92456

Cheaper @ West Marine

With some more info too.

Dims 7-3/16"L x 2-15/16"W x 2-1/8"H

 

[Kny21]

I don't see it fitting in a SJ. :dunno:

 

[ATS_Aaron]

Interesting, I like it. A little pricey, I wonder if it can run dry and not burn up?

Install a Wamilton's scupper. Then you will never have a dry hull.

Aaron

 

[FyrHazard]

I'm bettin you'd have to glue that strainer on to keep it in place

 

[2006superjet]

i would rather run another rule than drill through the boat. doing a scupper drain looks very scetchy. plus i leave the ski in the water sometimes.

 

[Waternut]

10mm is almost half an inch. My Attwood's don't leave that much...or if they do the difference is negligible.

 

[Waternut]

Just went down and measured the amount of water in my hull... I bilged out the water, let the water trapped in the tube drain back into the hull, and measured the water level next to the bilge pump. It's hard to get a perfect reading but I'm getting between 0.3" (7.6mm) and 0.4" (10.2mm) with my 800gph Attwood.

 

[Vongassit]

I have 2 500s fitted to my Sn, bonded in under the coupler. i have them on a switch, the new field sensing 650 is now on the market but as the 500s i have seem to like to cavitate a bit i stuck with the manuals. I find i have to cycle the switch on/off sometimes till they bite. They fit beautifully tho.:wink: