another total loss problem

[kingnothing3]

I put a brand new digital total loss system in my new ski. its starts great but if you try to rev it, it sounds like it hits the rev limiter.

my diagnosous: the led is blinking, so I assume I have a problem with my pickups. its a brand new system though.


So my question is where do I start? how do I know which one? what do I do to fix? both plugs have spark.

any help would be great! I need to get this sucker tuned before the rock n ride!!!!

 

[SuperJETT]

Check the airgap on the pickups first.

 

[kingnothing3]

thats a good idea. I have but it wouldnt hurt checking agian(first time was months ago.)

 

[kingnothing3]

its not the air gap. .063 I was hoping it was that simple. im just not that lucky.

 

[D-Roc]

do you have your switches all set properly? what are some stats on your timing curve and rev limit?

 

[SUPERTUNE]

MSD led blinking is normal when ignition is turned on.
Always double check the green trigger wires running into the backside of stator plate and make sure you don't have any rubbed wires that are now bare and shorting out.

 

[norcal ex]

I had the same problem and it ended up being the brain

 

[kingnothing3]

ooo no dont tell me that!!!!

ive double checked everything. my switches are all set correctly, everything is properly grounded.

static 28 degrees
retard begin 5000
rev limit 8000
max speed retard 15degrees

pink wire is hooked up to my kill switch
gray and blue are heat shrinked and not hooked up.