Aftermarket reinforced steering cable

OCD Solutions

Original, Clean and Dependable Solutions
Location
Rentz, GA
Never tried that tube.
Well, Im good. I have both Thrust cable and OEM 05-07 cable.


Sent from my iPhone using Tapatalk

I was told that if you put loom or some sort of protective cover over the thrust cable, it will last much longer. Apparently construction is great but the jacket is soft and easily rubbed thru and then corrosion starts in.
 
I was told that if you put loom or some sort of protective cover over the thrust cable, it will last much longer. Apparently construction is great but the jacket is soft and easily rubbed thru and then corrosion starts in.

I thought about that when I saw it.

Thanks


Sent from my iPhone using Tapatalk
 
First, the Blowsion steering cable is long. It makes a S turn under the engine in my Foot Rocket.
Second, I spiral cut old fuel line and wrap it around any abrasion prone areas on the cable.
Third, I had to grind a lot on my 62T reduction nozzle to eliminate the cable bending on it for left turns. Also take into account when you trim on a left turn, though that may be unlikely.
I'm unfamiliar with this ATP tube and can't comment on that.
 

SkiPro

Trim down for what!?!?!?
Location
E-Town, Ok
The blowsion cable is super long.. Its super long for my stock length SJ. It would be ridiculously long in a short AM hull... Also i mounted the cable on the bottom of the steering nozzle with a spacer so it clears the pump...
 
That's fine to mount the cable on the bottom, if you're not using trim. If you mount it there with trim, and watch it as you pull the trim, watch your nozzle make a drastic left hand turn...
 
Top Bottom