750sx finish by daytona

M

mikekilleen

Location
Deerfield ma
Started a build last winter. Life got in the way hoping to finish it amd bring to daytona.

750sx
part for build
Fresh rebuilt stock bore just hone and rings
Factory wet pipe
West coast head 30cc domes
New miller lightened flywheel(awesome dude to deal with)
West coast intake
Sbn 44
Hooker 9/15
Dual cooling
Converted to premix
Jss stator and coil
3833 cdi

Hull
Repaired
Footholds turf
New chin pad
Aluminum pole
Works scope intake
Work extended ride plate
Good straps
Limiting rope

Pump
Rebuilt new bearings and wear ring

Many people from this site have help me out big time so far.

Anyone feel free to chime in with advice or to point out any mistake they see would be appreciated.
Thanks Mike
 

Attachments

  • image.jpg
    image.jpg
    85.7 KB · Views: 67
Last edited:
M

mikekilleen

Location
Deerfield ma
Carb settings were per recommendation of people on this site. Put it in the water had drivability issues. Bogging as though very rich. And quickly fouling plugs. Exhaust manifold was getting a lot hotter than I was comfortable with. Very small oil present in water where exhaust exits ski(leads me to believe unburned fuel in exhaust manifold). Jug, pisser and rest of pipe where cool. Decided to go through electrics system. Next test ride it will have new coil stator and new miller lightened flywheel. Hopefully Thursday.
 
Last edited:
M

mikekilleen

Location
Deerfield ma
image.jpg cooling is 2 lines from pump to exhaust manifold(ball valves in line)Used factory pipes plumbing head to top of pipe. Bottom of pipe to tee. Tee to stinger with fcv. Tee to pisser. I used a lot more hose than they recommend to relocate the flow control valve to an easy spot to change. Could this be a problem? Will take out valve and make hose length factory pipe wanted to rule out. image.jpg
 

Attachments

  • image.jpg
    image.jpg
    112.3 KB · Views: 61
M

mikekilleen

Location
Deerfield ma
Back together going in the water now. Found another sheared key. Lapped and new flywheel. Check water box with little leaf blower. Rubber flapped would not open. Removed. Removed flow control valve.
 

Attachments

  • image.jpg
    image.jpg
    108.5 KB · Views: 61
  • image.jpg
    image.jpg
    192.5 KB · Views: 59
  • image.jpg
    image.jpg
    100.6 KB · Views: 57
M

mikekilleen

Location
Deerfield ma
This trip was a success. Would not have happened with out the help of new miller machine, the lady from factory pipe, and a buddy James.

I am going for the footholds next.

Does anyone have any recommendations of some warm fresh water near daytona?

Hoping to play with tuning a bit and put a few hours on this ski before trying the surf.
 
M

mikekilleen

Location
Deerfield ma
image.jpg image.jpg First round of glass on the footholds done. Super happy with the quality of the foothold but if you have a 750 SX pick a different one. Since ordering them I have seen Tom's holds and another set a holds that would've went into the ski with less work. The floor and backing was all done with biaxle .2 high spots filled with the resin and Mattimage.jpg
 

Attachments

  • image.jpg
    image.jpg
    93.9 KB · Views: 36
You must log in or register to reply here.
Top Bottom