750 sx freestyle hull build

my dad bought this ski in pieces with another hull for cheap. hes gonna build the other hull thats in better condition and sell it to make some money. he gave the crappy hull to me so i can build it. :bigok:

what i plan on doing:
make it as light as possible
make it as good looking as possible (this means do everything the right way)
make an aluminum pole for it that will fit better then an sj pole
custom footholds
custom tray
possibly a 550 tank
im thinking about cutting an inch off the back :shrug:
fresh paint and turf


everything from my green hull will swap over, including my hood...
 

Attachments

  • DSCN7111.jpg
    DSCN7111.jpg
    66.3 KB · Views: 74
  • DSCN7109.jpg
    DSCN7109.jpg
    59 KB · Views: 101
Last edited:

Waternut

Customizing addict
Location
Macon, GA
Since it really doesn't matter, go nuts with it and have some fun. Start chopping and fiberglass in some cool lines. Whack the nose off a couple inches from the pole and reform it. It could end being garbage but it could be an absolute blast to ride too.
 

Waternut

Customizing addict
Location
Macon, GA
i wanna try to put the pole on the nose like a rickter but it looks to be a major pita

That's kind of what I was getting at. Only instead of moving the pole forward, you cut and reshape the nose a few inches from the current pole mount.

Think in terms of the altered picture below...
 

Attachments

  • DSCN7109.jpg
    DSCN7109.jpg
    58.4 KB · Views: 112
Last edited:
yeah, eff this build. the motor mount bolt broke off, the i cut a slot for a screw driver, stipped that, then the drill bit for the extractor broke off inside :banghead:
 
Top Bottom