Super Jet 701 some assembly required

[tor*p*do]

so i blew out my crank seal and found a hole in my crankcase: http://www.x-h2o.com/threads/86080-61x-motor-blues...-(&highlight=


this thread helped a lot! http://www.x-h2o.com/threads/68398-How-to-assemble-a-701-motor

bought some used cases and need to put this back together!

 

[tor*p*do]

OEM gaskets, seals, etc

 

[tor*p*do]

these cases look good!

 

[tor*p*do]

crank and seals

 

[tor*p*do]

crankcase together

 

[tor*p*do]

flywheel and bendix installed
love the cold fusion tool!

 

[tor*p*do]

pistons, new wrist pin bearings and clips

 

[tor*p*do]

cylinder

 

[tor*p*do]

intake and exhaust manifolds
starter
shark fab head

 

[tor*p*do]

outside next to my backup 650, ready to take back the ebox

 

[tor*p*do]

scrounged up a 46 mm mikuni that should work well :scratchchin:

 

[JetManiac]

glad you finally are about ready for the water...

 

[jetx]

Nice lookin motor!

 

[gto0209]

looks good!

 

[tor*p*do]

thanks guys!
the plan is to get it installed this week and fire her up this weekend!!!!

 

[Mdavies_02]

Looks great. What paint did you use?

 

[lmi-step]

Nice job!!!

 

[tor*p*do]

motor was painted when I got it, blew a hole in the cases and replaced

got the ebox switched over (MSD inside for rev limited issue with 6M6 ebox)

 

[tor*p*do]

dropped into my SN hull

 

[tor*p*do]

ready to test and tune at the lake!!! :fingersx:
fired right up first hit, seems to run great!
got the tuning specs off the carb pages-
61x/61x 185 psi 120/150 2.5 n&s 80 gram 1.5 Hi 1.25 Lo