28.6mm or 1-1/8” Bars

[DAG]

Where are you guys buying your 28.6mm or 1-1/8” Bars from? I know RRP makes them. Any other sport like Motorcross or MTB use them? I can’t seem to find this size anywhere. I’m looking for something straight or with as little riser as possible. Thanks for the leads. Or if you have a set for sale shoot me a PM.


Thanks,
-Ashby

 

[txsuperjetfreak96]

pretty sure pro taper has 1" 1/8 bars, ive seen some on amazon im pretty sure. i bought some 31.8mm bars from ebay in the past.

 

[Big Kahuna]

most MTB bars are 31.8. Downhill is moving towards 35mm now. Think I even saw an even wider option.

 

[Ducky]

pretty sure pro taper has 1" 1/8 bars, ive seen some on amazon im pretty sure. i bought some 31.8mm bars from ebay in the past.

Yea there are a good amount of protaper bars in that size, but almost all, if not all are riser bars. They dont seem to have any flat bars.

 

[txsuperjetfreak96]

Very true


Sent from my iPhone using Tapatalk

 

[DAG]

so RRP is the only one that makes 28.6mm or 1-1/8” straight bars?

 

[txsuperjetfreak96]

Options probably limited, go to metal store buy length of round bar to size you want, only problem with that ends would have to b milled down to accept 7/8 grips.


Sent from my iPhone using Tapatalk

 

[speedysprocket]

http://www.onlinemetals.com/merchant.cfm?pid=6998&step=4&showunits=inches&id=71&top_cat=60
~$20 plus shipping for the tube, then cut it down...?

 

[yamanube]

All MX fatbars are 1 1/8"

http://www.onlinemetals.com/merchant.cfm?pid=6998&step=4&showunits=inches&id=71&top_cat=60
~$20 plus shipping for the tube, then cut it down...?

This would require 1 1/8" ID grips, throttle, trim, etc.

 

[Ducky]

All MX fatbars are 1 1/8"

Yep, but little if any are flat bars from what I have found.

 

[E_T_03]

i m looking for the same thing. ive been looking for mx bar cause i know they have 1 1/8 size but the only problem with mx bar is that they all have to much sweep.
mx bar with no sweep are impossible to find