2015 fiberglass Phantom

[chucktor]

What pipe are u running? I had to mount my ebox all the way to one side do it would clear my head pipe

 

[96superjet]

Factory B pipe. Yea, Josh just told me that it might be a problem. Although, I am not using the stock Superjet eBox mounts. I chose to use rubber anti vibration mounting spacers. It causes the eBox to be mounted tightly up against the firewall. I'm hoping when I drop the motor into shim all is good and I don't have to move anything.


Sent from my iPhone using Tapatalk

 

[chucktor]

I can take pics of mine for u later. I'm all the way to the opposite side and still only have like 1/8" clearance.

 

[96superjet]

@chucktor did you use the stock SJ mounts?


Sent from my iPhone using Tapatalk

 

[chucktor]

Yeah

 

[jo5hi3]

I used couch mounts

 

[SkiPro]

Guys don't be scaring me with all this fitment who ha! Ill be using couch mounts as well! And just a b pipe! jo5hi3 what exhaust you running?
Can't wait to pick up my phantom at WF!!!

 

[jo5hi3]

rrp pipe

 

[chucktor]

I ran couch mounts as well. It all fits well.

 

[N3vrSat1sfied]

Drilling and tapping the three 155 reduction nozzles I have. Two of them are the upsweep type nozzles and one is straight. Anybody have experience with either type and their thoughts?

Sent from my iPhone using Tapatalk

Depends on the hull really. I run upsweep on my Aerial and I know few people that do on the DVX as well.

 

[96superjet]

Next question... First, it was a nightmare twisting those breather tubes up through the pole bracket. I ended up spraying everything with silicone spray, but it was still a PITA. I'm using a stock SJ pole bolt and supplied ATP spring and spring perch. The only way I could see running the breather hoses up into the aluminum tubes was behind the pole bolt. To the front of the pole bolt there is only like 1 inch of clearance. So, I'm assuming the breather hoses are run correctly. Now my concern is the steering and throttle cables. If I run them down the aluminum tubes they will of course go through the breather hoses. This will cause both cables to run behind the pole bolt and I assume rub/push against the bolt all the time. Will this cause a weak spot in the cable and cause them to rupture and fail?

Sent from my iPhone using Tapatalk

 

[SkiPro]

All I know is, that thing is pretty

 

[SmittySX]

Drilling and tapping the three 155 reduction nozzles I have. Two of them are the upsweep type nozzles and one is straight. Anybody have experience with either type and their thoughts?

Sent from my iPhone using Tapatalk

What are the up sweep nozzles stamped?

 

[chucktor]

 

[96superjet]

Two questions instantly come to mind.
1. Is that a stock pole
2. How much do you tip the barber?


Sent from my iPhone using Tapatalk

 

[SmittySX]

Eek!! An AM hull deserves an AM pole...

 

[chucktor]

It's a cut up rn pole. -9. Ran out of funds so this pole will work for now

 

[chucktor]

It does diserve a am pole for sure. But the bank account diserves a break and this pole will work just fine for a bit till I can buy one lol

 

[jo5hi3]

Looks like that pole needs to be a couple inches shorter.

 

[chucktor]

It's alot shorter then what it seems in the pic. I might have to go shorter. I'll find out once I get her on the water