1995 SN build

[D-Roc]

i cut mine up front, both sides for footholds and pulled the exhaust and added the scupper hole. i was able to clean mine out from those holes.

 

[demolition_x]

i was able to get all my foam out from a cut in the floor right infront of the pump cavity, holds, and the scupper and exhaust tubes.

 

[meatball]

I would naturally assume its because the water is migrating to the bottom of the ski. I am still amazed that your foam has such properties but alas, I give you benefit of doubt.

 

[StandupWI]

I have the exact same problem as you except my crack is on the right side. I recently just started cutting into the hull and I decided to cut out holes for my footholds, then cut out a hole in front of them to make defoaming easier, and lastly on the bottom I connected what two squares you have and made it into one big rectangle. So far this has made defoaming easy maybe I can get some pictures up in the next day or so I plan on making a little project build myself. Good luck with the project although defoaming gets bad wrap I just look at it as a learning process since this is my first foothold and defoaming experience.

 

[twitch]

Hey guys finally got to do some more dirty work, cut a hole for defaoming, and
found plenty of water and saturated foam, for the first defoaming job it wasnt that bad,

 

[Matt_E]

Nice job. Be sure to seal all threaded inserts, all tubes, and most importantly, the bondline.

 

[twitch]

hey i had to stop my project for a few years went to iraq and sadly they dont let you bring cool stuff with you, but iv dove in head first and gotten alot of work done sence i have been back, and i just want to say thanks to all you guys you kept me pretty sane when i got a chance to look at the site while i was in iraq here is what i have done so far,
installed foot holds,
used 3m 5200 to bond anything that was coming through the hull, and started working on my 701,

 

[tightithrash]

sweet man! cool to see you never gave up on it. its just going to be that much better when you ride it now.

thanks for doin what you do.:usa:

 

[twitch]

now what is the deal with putting the foam in do i have to seal all the holes after i pour the foam in or what, im a little confused cause iv read and seen people pour it in and its overflowing out of every hole, and should i do a little at a time or pour as much as i can in at once