Super Jet 1990 sn sj build pole help ? ? ? ? ? ?

[jeremy chambon]

hey im starting sn build and im in the part collecting stage and i have a shortan pole and umi quick steer and a blowsion pole bracket but i im not fond of the pole design when i sit on the chin pad to do tricks and what not the pad hits the bars where i cant steer and i was wounder what kinda pole most guys are useing and will my quick steer and blowsion block work?

 

[agua]

was the shortening done in the middle? this is why most people use a rn pole

 

[jeremy chambon]

nope its an after market pole but the after market poles dont fit the hood line very good and im just not that fond of it but will my quick steer fit a round nose pole?

 

[agua]

not really sure, im shorting my aluminum sn pole, but im taken it off the long angeled part

 

[jeremy chambon]

yeah mine was never cut it came that way. Do u know how hard it is to put the x2 trim set up on the sn and Im putting foot holds in but i want to defoam mine bc im going to cut the hull about 3 inches of at the back does the foam help with the structure of the tray? its my spare hull so if i mess it up im only out 150 so i would like to do a full make over

 

[TB]

hey jerry i have a stock length rn pole on my square and don't have this problem at all...and yes your steering will swap over to a rn pole...wanna trade? i'm local to you.

 

[orangefinger]

If the pole has been cut at the bottom more than -2 the upper part of the SN AC pole or any SN pole will not rest within the SN hood anymore....you will have to widen the upper corners of the SN hood or leave the turf pole and corners of hood, but then the pole will not be plain with the hood.
For alterations of that kind I would recommend any RN oem pole or aftermarket RN pole thus these are less wide on the top section and can be easily cut down without hood alterations.

 

[jeremy chambon]

mines aluminum it was never cut or any thing its AFTER MARKET not custom