superjet 701

Hello, In an 08+ superjet with a factory pipe, the fuel/water separator sits very close towards the end of the pipe. It hasn't caused any issues yet, but I'm worried about vibrations over time damaging the bottom screw of the water separator and causing some fuel to leak. In most photos I've...

I recently bought a 2008 superjet hull. I have the motor, electronics, handpole, and half-shaft. I pretty much need everything else though. Including all mounting hardware. Does anyone have any of these items? Internal fill gas tank waterbox exhaust tubing throttle cable steering cable chin...

So, recently my family just bought a 1994 fx1 and a 1995 sn sj. Both of them are completely stock and have not had a single upgrade besides a bilge in the sj. I want to ride some light free style for fun with the sj or fx1 whichever one is better for it I will mod. I'm 16 so I don't have a huge...

Looking to purchase a rickter edge hull near New York. Pm me with what you got. Willing to purchase complete and trade my mint FX1 as well.

2015 backie Chan aftermarket freestyle hull Yamaha ported 701 61x power plant. Ada girdled head with 35cc domes (185psi compression) pump gas Msd enhancer 62t electronics Jet works flow control valve Factory b pipe 2.5 gal tank  Jet maniac waterbox 148 mag pump Thrust trim with alloy...

I have an 01 superjet that runs fine on land, but when it’s in the water won’t run at WOT. Once you go past 3/4 throttle after a few seconds the ski will stop and when you give throttle it revs up but won’t move. Also sounds like a metal on metal noise when its revving. Usually after keeping it...

Starting a new project on my ‘91 square nose to swap my 650 with a 701 and I’m hoping to get out on the water by the 4th of July (or sooner). The 701 has a 62T case with a 61X top end. Looking for some advice and recommendations on the following: • Should I keep my 6m6 flywheel, electronics...

I bought this SuperJet 10 years ago and shortly after I did an overhaul on just about everything but the engine. I recently got it out of storage after sitting for about 8 years. I winterized it properly, and it started right up with new plugs and fresh fuel so I took it out for a spin. I...

looking for a wdk rip jetski looking for complete or the hull. let me know if anyone has anything

My steering cable is new but keeps pulling apart at the nozzle metal rods. I push it in and it clips but if i pull with slight pressure, it just pulls out. How do you tighten it or stop it pulling out ?

May part-out if it makes sense. Thinning the Rickter herd as I am having a race ski built and since this is my freshest ski, I decided to let it go. Clean/clear Oregon title. The motor has less than 1 hour of break-in time on it and was built by TigerCraft. 155 mag pump 46 Mikuni's New Yamaha...

Has anyone seen this cdi unit before it was in my 00 sj

What's the go to 4Stroke ski for buoy racing?

have a Brand New 2021 superjet 701 with stock carbs and tuned perfect, hits super hard, idles great, starts everytime in 1 sec, but out in waves every time i TURN LEFT 180 or more or jump carb dies (sound like goes lean for 2 seconds) and then back to ripping again? what'd i do wrong?

2017 Yamaha Superjet in prime condition Built by TC Freeride TC Freeride ADA Head Blowsion Flame Arrestors Factory B-Pipe MSI Ignition Enhancer Jettrim Turf $12,500 OBO Ski is clean & has zero issues. Located in SoCal. Pm for further questions

I have a 17 Superjet and need to install a bilge pump. Not sure if i should go with a dual bilge setup or just one? What switches does everyone use and how did you rout the discharge hose for the pump?

Hey guy im thinking about buying a wdk rip or wdk riptide complete ski. They both have a 701 in them and both are in good condition. What would you guys recommend for a beginner flatwater freestyle ski. are the hulls pretty much the same?? also they are both the same price its just the riptide...

$380 USD or $480 CAD - Live in Canada work in USA can ship out of either county. Buyer pays PayPal fees and shipping. These are getting pretty rare these days, very well built old school AC aluminum racing pole, includes chin pad. This came on my SJ which I have since sold so I don’t need it...

I have an xscream/xmetal handle pole for sale as is. custom art on top looks sweet. I have two so no use for this one. Make me an offer need gone $450

I am selling my 2012 Superjet. This ski has been upgraded with the following; Glassed in Footholds, Factory B pipe, ADA Racing girdled head among a few smaller upgrades. This ski is far from cosmetically perfect but is incredibly fast. 1500$ of work was done by The Ski Clinic in Antioch this...