Search results

:haha::haha::haha: I've got one rotting in my yard if you want it:cool2:

pic 1 is the buck for a wider tray, pic 2 the mold & pic 3 vacuum. Carlito gets silly with his attension to detail. :biggrin:

Cool pics!!!:brap::brap::brap::brap: I like ridding Seaside:Banane01: That beach break was fun doing off the lips @ 10 ft from the beach to berm shot in dry sand. I had my ski barrel rolling down the beach a few times & scrached my hood & pole up in that gravel sand they have there:cool2...

finshed glassing the tail & rideplate hardware. Filled in the areas that were removed with foam sheet. Need to do some filling & sanding to smooth things then I'll glass the tray.

me too. If not mix a hot batch of resin:cool2:

today I cleaned out the foam from the inside of the tail & removed the ride plate mounts from the peices that got choped. I also removed the rail lip from the rear & the wedge riser over the pump. I'm trying to lower the tray as much as possible. The pump hardware will end up exposed in the tray...

got both sides & the lower rear glassed. next i need to do rideplate mounts then the tray. hope to be in the water next week. i'm really anxious:cool2:

what five0 said:arms: here would be my priority list: 1 seal front hood openings 2 1 bilge pump 3 tow loop 4 flush kit 5 prop 6 b-pipe

If this works out I'll get some befor & after vid to compare. At worst I'll have some opinions on what works. If the nose needs to come down I can either norrow the nose or widen the tail. I did'nt consider how harsh flat landings might be but I should'nt be in the air anyway. My knee are...

Glassed to first side & started cutting & shaping on the other. I'm thinking it's going to ride high on the nose but... I like ridding with my weight in the front of the tray, that's where my wide point is. The rail is shaped like a surfboard with a soft rolled edge in the front to(in...

Tubbies are good so more would be better???? That's what I'm going with. Tore the glass off a surfboard & used the foam to extend the tubbies & reshape the enitre rail.

I want to shorten the tail last year but instead went conservative route. removed 3 1/2 in. off the tail:

Got some ideas to try this year so out comes the tray again

I ain't stingy:cool2:

Ouch!!! perkasets wrench my tummy. I've got better than that if you need:purr:

I filled the missing part with silicone

You suck!!!! :damnit: :tool: :nutkick: :hitwithrock: :buttkick: :slap: :moon: :angryfire: :joke: I'm only jealous cuz you finish what you start:You_Rock_Emoticon:

That's F***ing awesome:Banane01: Can't wait to see Franks face peeking out a barrel:woot: