Search results

Gil... Was it a 5 or 8 mm cylinder? Was/is it Paul's epoxy work? Why would he care? Yes u told me it was on last bore.... Just not how wore out it was.. Sent from my XT1080 using Tapatalk

What ever happened to no thread bashing? Does that not apply here? Sent from my XT1080 using Tapatalk

It seems to me that you didn't know what you were even selling. This motor which I still have is worn out to the point of it not being usable. You told me it was just redone with light hours. I'm going to tell you right now it was far from lightly used. You said it was on last bore yes. But you...

Gil...this(ur old setup) has worked great.. For you.. You got paid... Do you even know what u sold??? Is it a +5mm or +8mm cylinder? What was/is the piston clearance when you sold it to me.. Was it within spec? Whoever installed epoxy did in a sloppy way. You could have showed me or told me...

Big K, just more familiar with rius. Know for FACT that he was involved/design in the new 08+ design of the superjet.... He wasn't alive wen Jacobs won first worlds :) Sent from my XT1080 using Tapatalk

Hey turbo... U beleive that only HP only can win a race? That rius statement is very true... Chris mac is one also... Think ric Roy/eric Malone could do more, with less, and in the beginning.....of any builder's... Career, U start somewhere... This is were the thread started... Sent from my...

Scotty..legit question....if bearings are too tight @7900...is there a difference @7100... Sent from my XT1080 using Tapatalk

Scottie chill out.. Take a punch if your going to swing first...and if rius showed up a race on a limited ski... He more than likely beat ANY horsepower..Jacobs might to! Sent from my XT1080 using Tapatalk

? Sent from my XT1080 using Tapatalk

Chris I don't know what your talking about I asked about watermigration with OEM gasket with holes Sent from my XT1080 using Tapatalk

Its r&d piston from GIL Sent from my XT1080 using Tapatalk

That's actually a r&d piston. Not tpe Sent from my XT1080 using Tapatalk

No more bullying Sent from my XT1080 using Tapatalk

Devcon Sent from my XT1080 using Tapatalk

If u can build the best skis on the east.... Why can't u install bearings into a solas pump?? This thread started in an ok way. But the bully posts make no sense. Maybe some people should use quality bearings rather than the least expensive. Sent from my XT1080 using Tapatalk

Zimmy and chris what causes a piston to wear like this? Sent from my XT1080 using Tapatalk

Flowgration.... Why do oem gaskets use various "holes" to control water direction? Sent from my XT1080 using Tapatalk

964chris has there been any problems with "water migration" or thermal concerns with your setup? Sent from my XT1080 using Tapatalk

It actually is migrate is a better word than flow because it described more of what's its ACTUALLY doing Sent from my XT1080 using Tapatalk

Two stoke... Up/down... Once all intake charge is "in". Piston goes down and creates "primary"compression whichs causes "charge" to go different ways to the the place it has to go...the combustion chamber... Not the same "flow"as like a 4 stroke.. Sent from my XT1080 using Tapatalk