Search results

Heard it was Dustin Motzouris

I thought that was a TNT manifold

Going to dump water into the collector to dampen noise?

1st startup video???

I used clear hose over bolt, 8mm ID - 10mm OD. Cheap and easy

SXR tank, have to keep it pure

Get that thing done! I want to see Sean's knuckles dragging on the ground from the way that thing stretches his arms.

You can run 2 springs for extra trension, still gives full travel

OEM Kawasaki and Yamaha coils, removed curve switch, new solenoid. Still the same problem that would come and go

My MSD is in, no other changes done to ski and same timing curve, engine runs smooth, no kicking back. So much for ATP saying it was my carbs. I could get a slight kickback if Start Retard, and Electric Start were Off but nowhere near what the TS2 was doing. Definitely is a problem with holding...

Still no flash from ATP, they are apparently still water-testing

Where are you based? I am in Jhb but brought in a hull from Japan in 2007 when I still lived in PE, brought in an engine last year and smaller stuff this year. Shipping can be done on seller side or you can arrange, you will have to pay clearing fee and VAT when it arrives.

Sold through Kommander in USA, but made in Richards Bay South Africa by Dustin Motzouris's company Z-Craft. Dustin now lives in USA and in business with Steve Webster of Kommander

Software actually not ready yet, have to wait I have ordered MSD TL, RRP ebox, etc from Thrust but they are so busy that it has been 10 days and they haven't got to my order yet

Loosen bed plates on crankcase and push them into engine, maybe also elongate holes, re-tighten crankcase bolts

Updated software, news on ATP site, I have emailed for them to send me the software: In line with our constant development , We are pleased to announce a new feature for the TS2 Flame Ignition. This enables the user to further retard the cranking timing up to 30 degrees. A new version of our...

Cast heads are never accurate on squish

Talking about PFP Work out the area at the flange and compare to exhaust port

Also looking for a new manifold as all current FP manifolds are too small in ID, need something starting at 52mm+. FP manifolds are only about 47mm ID. DASA 1200 exhaust port is equivalent to about about 54mm ID

Where can I get a pumpshaft for a Kawi sb pump? Snapped mine of behind the threads.