Search results

RRP Enclosure---$200 Free shipping to Lower 48. Thank you. Rod

So, I had just bought this last week from here thinking I could use it for a standard ignition system---I was wrong. These are Total Loss specific. Anyway, just putting it back on the market.

Low hours on it. I just went to a laydown pipe so it can go. Ships to Lower 48 at that price. Thanks

This is a low hour pipe. Has a small rub mark but is not an issue. I installed a longer coupler for better fitment. Free shipping---Lower 48. Thank you, Rod

Hi again- So I am installing a Power Factor laydown pipe and it is necessary to install strap hooks onto the hull to support the pipe and waterbox as well as the new fuel tank. Blosion has billet strap hooks and I was thinking I could set them in epoxy. The photos Power Factor provided shows...

I bought this in Aug. '23, rode it a few times then parked it. I no longer have a use for it and need the space in the garage. It's been in fresh water only and it runs perfectly as it should. As for fuel, it has only had AVGAS in it as that's all I buy anymore. Title in hand. Delivery to...

I checked the spark plugs on my Dasa 1100 yesterday to check the tune and found tiny water droplets on one spark plug. Pulled the head off and the dome had larger drops. The other dome was dry. Anyway, my guess is water is entering the cylinder at the exhaust manifold as the o-rings were fine...

Hey guys- I just took the ski to the water to do a water test while it was on the trailer and it fired right up. I had the flame arrestors off and immediately noticed fuel being ejected up and out of the front carb. It stumbled and would not stay running on its own. I restarted it a couple times...

I am looking for a SX-R 1500 motor.

I bought a used Rickter with a "professionally" built 735 with what the seller claimed had around 15 hours on it. It was set up to run on pump gas at 40:1. I installed an hour meter on it once I got it for all the reasons you do that. Anyway, I noticed that it was not as snappy at about the 2-3...

Hey- So, I found a low hour 2019 SJ motor package on eBay a couple months ago and finally got around to installing it today in a Rickter. Before I installed it I rejetted it for a b pipe and head. Once installed I fired it up and it idled near perfectly. What is odd though is the fact that when...

The hull has low hours and is in very good condition. The photos were taken 2 weeks ago when I had listed the ski for sale. I have since decided to sell the hull. The handlepole is NOT included in the sale price but can be had for an additional cost. $8500.00

May part-out if it makes sense. Thinning the Rickter herd as I am having a race ski built and since this is my freshest ski, I decided to let it go. Clean/clear Oregon title. The motor has less than 1 hour of break-in time on it and was built by TigerCraft. 155 mag pump 46 Mikuni's New Yamaha...

Hi- I'm looking for a lower hour ski. I'm in Oregon but I can travel. Thank you, Rod

I'm guessing it has around 35 hours on it and it runs perfectly. Fresh water only--never been in salt. I've been bitten by the Rickter bug and have no need for the ski. It's located in Portland and shipping is on your dime. At $7,000.00, the price is firm.