Search results

With the long boring winter here in Michigan, I decided to take on a project. On my Rickter XFS Ninja Comp, I intalled the Rickter Hood Scoop per recommendation to allow more air into the engine bay to allow the motor to breathe. As anyone who has done this knows, this requires you to drill...

I owned multiple dvxs and then got the helium when they came out (900rr powerplants). After 2 heliums, I actually went back to a DVX. Being a smaller rider (about 170lbs), the helium is so stable that I could not get the ass end of the ski down during setup wakes, still cannot on my buddies...

Hey guys, Recently acquired a PHP1015 and looking for a long blade prop for it. Pitch is approximated at a 10/17 long blade. Thanks, Bobby

Good instructional video on how to do everything right

Not sure what your planning on for motor buy my sfs circus with a ported 760, msd enhancer, pfp run wet, oem 155 with jetmaniac prop was a riot.

Found. Thanks guys!

Pressure test your PFP chamber. If it's broke that would explain the lag/lack of rev feeling you're experiencing. Ski will sound great out of the water but as soon as it hits water you can feel a very inconsistent ski. Like others said, you should be pulling at least a 9/15 - 10/16 with...

PM Sent

140 Main 142.5 Pilot 2.0 N/S 95g #60 Return 2 Check Valves Jetting is from my old XS900R race gas setup Your compression numbers do seem high for an xs motor

the heel blocks themselves are premade. They take a little sanding to get them to fit perfect but yes they fit in XS foothoolds on dvx/helium for pricing message tricky

order the premade kits from @tricky1 when set up correctly there is nothing better....especially on xs hulls

@JKMike im running into the same issue on my new xfs. I am going to cut out that oem battery mount thats epoxied into the hull to drop the waterbox down. A buddy of mine cut and rewelded the waterbox, but I think im going to pass on that route.

@Storbeck From what I can tell/have heard the LS1 the booster is not "centered" in the carb. Its offset so the fuel doesnt dump directly on the throttle shaft and disturb the flow or when the carb is at full throttle it doesnt dump on the plate, it dumps directly down the throat of the carb

why are 2 girdle studs missing out of the cylinder? exhaust side middle and rear

ttt

Hey guys. Just wondering if anyone knows any shops that do prop cutting and approximate cost. My prop is not close enough to the stator section. Thanks, Bobby

yes

Bump

Have a nice raptor trim in the parts for sale section

here’s a pic of the xs in a q8 build we did for reference. If I recall the Ariel does have a little more room to work with.