Search results

Are you running the correct manifold to headpipe gasket? There are two different ones and you want the one that does NOT let water through.

Put very large thick washers on the back side of the hook and you will be fine *until the tube goes underwater then you will be f'd. Also dont pull more than a small single tube.

RN cable is the correct cable. The Reaper uses everything from the 2008+ SJ's.

Unless you are renting. Then you dont need one.

This ski needs one of those Mariner clear hoods. :D

Interesting. Wonder what octane the fuel is.

Found a pic of her: :P

One time on a 62t midshaft. I pushed it back in and its been fine ever since. No idea on the cause.

Call the 1800 dmv number with the vin and ask how much is owed on back registration. If they say it is not in the system; buy it and fill out a lost title for it. Say it is yours and it wasn't running so you didn't register it for the last x amount of years. Easy peasy. If it is in the system...

someone recently posted a picture of the Factory pipe dyno setup on one of the fb pages.

Take it one further and leave the sparkplugs out of the ski as well.

Have you played with 3d printing impellers?

when are going to start seeing jetski impellers like this?

clean the carb and tighten/replace the ground cable. Ride the ski then do any rebuilds/mods in the fall/winter.

Did you come to the west coast for the freeride?

Gas tank was weeping so I bought the machined disk that fits perfect. Replaced the plastic filler the gas cap screws too. Threads all broke off at the end of last season. And have a new choke cable on the way.

Fun video from the Donut guy on meme coins.

@gsxral1000 might know?

Is it pulling that info from the X or from reddit or both?

I either bbq'd or air fried it first.