Search results

I took off my flywheel cover and there was oil in it. It smells and looks like motor oil. Does 2 stroke oil eventually look like motor oil. I dont think the crank seal is leaking it looks good but theres a bunch of this oil all other the stator and what not is it supposed to be there or do you...

what has to be done to put a girdled head on a 62t cylinder

I read on the Jetinetics website that their flywheel doesnt fit 62t cases. I have a 62t motor out of a waveraider. What would be the best charging flywheel to get and where is the best place to get it. Also would a girdled high compression head or a lightened flywheel make a bigger difference in...

I just put a 701 out of a waveraider in my superjet and it has a msd enhancer and protec pipe. When I put it in the water it will run good for a couple minutes and then just cut out and not go above 1/4 throttle. I hooked the gas line from the gas tank right to the carbs and took the breather...

I just put a 62t 701 out of a waveraider in my squarenose. First of all the CDI and starter relay were bad so I put those parts in from my 650 ebox. Also there was a white wire with a red stripe in the ebox that had two male ends so I left them unhooked. The motor was just rebuilt and has an...

I got a 62t 701 for my squarenose and it was just rebuilt what should I do to break it in.

I have a square nose that had a 650 and now has a 701 62t I had a protec pipe on the 650 and was wondering if it will work on the 62t or is the manifold the wrong size and if so can it be opened up to the right size?

will a lowered roundnose handpole bracket work on a squarenose or will the pole not sit right on the hood

how much 2 part foam do I need for a superjet tray

I have the tray cut out of my squarenose and was wondering what the best way is to re foam it. Should I glass the tray back in and drill holes and dump the foam in or put the foam in first and them trim it down and glass in the tray. If I should glass the tray in first how many holes should I...

will a roundnose lowering bracket with a stock roundnose pole sit right on a squarenose hood

what is better for a superjet a 760 or 701

what is best to use for filling chips and dips in a jetski is bondo alright or should something else be used.

what is the best way to cut the tray to defoam cut the whole tray out or just the floor and squares in the sides

I have a squarenose sj I just stripped everything out of to reinforce and paint. When I did I realized a crack about a foot long. It is in the bottom half of the hull right under the bondline. In the middle of the crack it is kind of split and pushed in a little and the fiberglass is wet. If I...

i have a 1990 superjet and need a midshaft will any superjet midshaft fit or what do I need

Has anyone made their own nose or nose piece for the squarenose if so how did you do it and do you have pictures.

wheres the best or cheapest place to buy an x-metal pole for a superjet

I am trying to figure out how to put a roundnose handlepole on my squarenose. If I get a roundnose bracket reinforce around where the bracket goes drill holes and make a backing plate will that work. Can I just move the hood hooks that are on the hood will they still work. Also I heard the...

has anyone had a protec pipe on a 650 sj if so how does it hold up and does it make a big power difference