Search results

i am going to send my electronics off to jetski solutions to get them cleaned up and tested, I have 2 cdi and wanted some opinions on which to use. one has the rev limiter mod the other is stock. Dont know if it matters but the electronics will be going in a ski with a jetworks big bore 771...

I did a quick search and didnt see what I was looking for. I need to put some inserts in the bilge area to,hold down water box and gas tank. Whay should I use for inserts? Should I use 5200 to secure them? Thanks in advance

I am getting ready to put my ski back together and I was checking the fittings for cooling lines on bottom of my exhaust manifold and they appear to be 1/4 fittings with 3/8 outlets, I thought they where supposed to be 1/8 by 3/8. Is the bigger diameter of the threaded end going to allow to much...

I remember reading that you can hook a bilge up to the stop portion of a s/s switch, and use the lanyard portion to shut the ski down. Hopefully this makes sense. Does anyone have any info on this?

Well I cant seem to find a used aftermarket intake for my engine, and as of right now a new one may be out of budget, is there anything that I can do to modify the 64x intake I have so I can put dual 44mm black jacks on it. Any advice would be great. I am sure this has been covered but I cant...

My 44mm blackjacks dont fit a 64x intake. What intake do I need??

Ok so I have narrowed down my choice to a couple of engine builders and really dont know how to decide. I figure I could ask for ride reports on both motors, I have used the search funtion and havent really came to a conclusion, so I was hoping for some real world ride reports. Engine choice is...

I have searched and only found really old posts about sbt cranks and hot rod cranks. I was wondering if any opinions have changed on either brand or if there is something better. A couple bearings on my crank are somewhat noisy and I am getting a motor built so I figure I should replace it. Its...

So I was pulling my cases apart and found a nice crack in the bottom of the case. I need a new bottom case, however I noticed 6m601 stamped on the bottom case, top case says 62t. So is it possible to use a 650 case on the bottom? 6m6 was the 650 motor right? also how do you tell if crank...

i have the oppurtunity to buy a 2003 superjet that needs a new top end for 2700$. the ski has a bpipe aftermarket girdled head 12/17 impeller umi steering plate foot holds and water box, forgot what kind. the motor is a 760 from a raider, but i can also get the 61x head with it as well as a...

Is it possible to run breathers in a stock rn pole

how many posts do i need to pm

Do I need to run the stock water pickup in the 650sx hull? Its the little black box under the coupler, or can I block it off , I want to put my rule 500 there

i am getting a superjet with a 760 in it, it needs to be rebuilt, I am unsure of the damage right now, but here is my question i am also getting a 61x cylinder, is there anything i can do with the 760 cases and the 61x cylinder? i have tried to use the search but have only gotten more confused...

just wanted to introduce myself, my names frank, I have been lurking around this board for about a year and figured it was time to register. i have been off a ski for a few years but am finally in the process of getting a couple skis again.