Search results

Selling a '96-'07 fitment driveshaft. This came out of a pump I bought, so I have never personally ran it. Overall, it seems to be in ok good shape. The rear threads are a bit banged in from the previous owner and it looks like they also attempted to clamp the shaft when installing or removing...

Very nice condition 08+ Superjet impeller. SOLD. Yamaha part number 6BA-51321-00-00

Two near-new condition black Blowsion 45 degree by-pass fittings. Only used for one season. SOLD.

Looking for a used Worx WR202 intake grate for a 650sx/X2.

Selling a Riva Racing billet finger throttle. Lever rotates about the mount for increased adjustability. SOLD

Got a few Kawi 650sx/X2 parts that I'm trying to sell: Crankcase drain blockoff - SOLD WSM Crank Seals - SOLD WSM Engine Mounts (per) - $10.00

Selling two clear anodized Blowsion 45-degree bilge fittings. SOLD The one has a few little knicks in it, but functions just fine.

Selling some stock Superjet parts that I've got lying around that came off of a clean 2009: Flame Arrestor, with upgraded stainless hardware - SOLD - notched for girdled head Stock Pump with pump cone - $45 Pole Mount Bracket - SOLD Head, with head bolts - SOLD Wear ring - SOLD Complete Reed...

Looking for an OEM or single-hole billet RN pole bracket. Yamaha part number FX1-6133C-13-00.

Looking to swap my 2009 steering cable to a longer throw 96-07 style. I'm wondering what peoples opinions/experiences are on OE vs Aftermarket though? Yamaha also had two cables during that era, GM6-61481-00-00 ran from 96-05 and they had GM6-61481-10-00 from 06-07. I understand the 06-07 is...

Wondering if anyone out there has a lightly used Solas 144mm 12-Vane pump that they are looking to part ways with.

Was wondering what the best method of putting a B-pipe manifold onto a 760 cylinder is, drilling out the B-pipe manifold holes to accept an M10 size bolt through them or helicoil the 760 cylinder threads from an M10 to M8? Pros/Cons to one over the other?

Looking for a clean, good running and good compression, Yamaha 701 short block. Basically just need crank, cases, cylinder, head, and pistons. Intake and carbs are a bonus, but not needed. Located in the Minneapolis, Minnesota area. I can do a local pick up or else shipping would be required.

Wondering if anyone has ever removed the throttle spring on the PTO-side carb on a stock SJ dual-carb setup to lighten the throttle lever pull? I can't see a need for needing both of these if just the spring on the mag side carb (one that the throttle cable actually attaches to) is enough to...

Wondering if anyone has a Factory Zero, JetLift, or Tiger Tote beach cart for sale.

Looking for any advise or insight on where the best place to get a 650 kawi crank rebuilt is. I see that SBT sells a complete replacement crank and WSM sells replacement rods and bearings, neither of which I am interested in for quality reasons. Anyone know of someone that can rebuild a...

Does anyone know if someone makes a billet e-box fitting for the 650/X2? The part I am referring to is Kawasaki part number 13183-3712. It holds the rubber grommet on the wire harness tight up against the e-box cover. I broke my plastic one and they seem to be hard to come by and the ones that...