Search results

Oh and u can use literally any flywheel with my system.

You cant get MSD anymore. It’s discontinued. Zeel is good but doesn’t have very good pickup resolution with factory 2 point trigger so I’m convinced it’s not as accurate as we want when crank speed fluctuates. I’m using a much higher resolution trigger wheel. I’m also using tunable smart coils...

Ok cool cool. Not sure if you secretly have a strong opinion about how bad this project is or if you just have an opinion on the connector haha

also, for the record, this will be very cheap. I'm not looking to go into the jet ski business really... just looking to help the sport. The boards currently have an assembled cost around $25 at pretty low volume. I need to make a few changes that could drive this up a bit and the cost of...

Some of you may know I've been working on a new ignition for our sport. It's really a car ECU (based on Speeduino) which i've trimmed down to mainly just whats needed for ignition control. I have a couple open design questions and would love your feedback Connectivity I can either have wires...

Probably saw this and it’s a complete motor but just in case https://www.x-h2o.com/threads/engine-tech-900x.206689/

DASA, the overseas guy MX100, I think some other overseas guy, Erickson maybe. They are in the $3k range though. That epoxy is easy to fix. Just clean it up and fill with JB weld

Thanks. This thread is 3 years old. Not an issue anymore :)

Never did with that 1015… but ya, I’ve come a long way lol

ok cool. Thanks for the info!

Oh right I was mixing up acronyms lol. I need to go look at a crank. I’m wondering if the flywheel shaft and output shaft are part of the outer webs and not pressed in.

cool thanks. At least thats a potential source for the pins/bearings/rods though aren't WSM parts kinda questionable?

I'm sure I'll never do this, but i was thinking about cranks and how the webs aren't really that difficult to machine (just bought a new CNC mill so I've been thinking about a lot of this stuff). Does anyone know if you can buy the pins that go between webs and the input/output shafts. the...

I haven’t done too much testing but I did experiment with an insert on a power factor. It ran worse all over on my TPE 12. I then cut the stinger off and welded on just the larger tube. Made a nice power increase across the whole power band. Obviously every motor is different but that was my...

Flippable electric jet ski would be awesome. Unfortunately the battery tech isn’t there yet. Look at the weight of a Tesla. Apply the same percentage weight difference on a jet ski and you have, idk a 500 or 700lb stand up. Just doesn’t work.

Also make sure carbs are in sync

56. Same as 760

No, leave +/- on. Set lobe count to 2. Pink wire controls map switching. U can set it to high low or both to switch.

I could run down a list of stuff to check but I guess look it over. If u don’t find anything let us know. Check for… exhaust leak, fuel pump issue, clogged return jet, slipped stator, bad plugs, bad coil, carbs out of sync, something getting too hot and steaming, carb screws out of adjustment...