Search results

So I’ve switched to a 155 pump and this stuff needs to go. I basically have my complete 144 mag setup minus the driveshaft. Will sell complete or in pieces. All parts are from a fairly fresh build. Maybe 20-30hrs at most. Thrust Innovations trim. Includes brand new never installed cable - $575...

Just like the title says, does everyone wear gloves on these aftermarket hulls when doing backflips and stuff? I've been attempting backflips with my Havoc (and failing miserably). I've lost grip several times trying to flip off boat wakes. It is probably just a loss of strength (this thing...

Hey Folks - I have a standard length XScream pole on my havoc. I need to swap it for a comp length pole. I'm planning to order the comp length from them today or tomorrow, but before I do that, I figured I'd see if anyone wants to swap? It's in very good shape with two very minor nicks.

Hey All, This will be a very broad question with lots of opinions I'm sure, so I apologize in advance.... In April, I'll be allocating approximately $10,000 - $15,000 (depending on whats needed) to build/buy a flatwater ski. My goals are to have enough power to backflip pretty easily on...

Man I feel dumb. Got a shiny new impeller from my wife for my birthday. Install was going great. Everything had anti seize and cane apart great. Went to take the prop off the shaft and would not budge. Knew it was backwards threads and checked it was the right direction several times. Eventually...

Hey All, I've got about $400 to aimlessly spend on my superjet. I'm between an ADA head or a 9/15 hooker impeller. It currently has a skat trak 12/17, and i feel like it must be worn, cause i just can't get it to hook up at all. Always feels like the motor is revving but i'm not moving (until...

Hey All, I'll be on vaca in Corolla, NC the last week in August. Where do people ride down there? Thanks! -Jordan

Hey All, I have a coffman sizzler installed on my mildly ported 701 with Stock head (for now). Its the shorter version of the pipe (either that, or its been cut down at some point in history). I believe the shorter version was better for top-end, but I'm more interested in low-end. Has anyone...

Hey All, I'm about ready to get my coffman sizzler installed (bought used). Regarding the small gasket that connects the manifold to the head pipe - should it have holes for water to flow through or no holes? I was perusing pictures of new pipe kits and the gasket APPEARS to have no holes, but...

hey all, I’ve got a RN with a somewhat tired 61x (135psi in one cylinder). It runs ok, but I’ve got a great compression 62T laying around and a set of porting templates I’m itching to try. What problems will I run into if I port this 62t and install it in the superjet? I plan to use the 61x head...