Search results

SUB

Is your needel seat wet from fuel or wd40 ?

Here is mine on the scale was a back up from Lee Stone have not run it yet lookes good though

Get B pipe jetting as starte point.

How about the shaft ?

On a side note i dont varm my ski up on the trailer before going in, i starte it in the water soo cold water dont hit a hot cylinder. Dont know if it makes a diffrent but i think it makes sense

I have seen a couple off 61x bored too 84 hade a 62t my selv bored too 86, Group K is a bit conservativ but have lots off great info.

I run a simple valve att my hothands/pisser i Can then ajust too the engine temp i want. Remember that change engine afects carb settings.

If you Can get you hands on a stream cleaner that works

I ran a 1000 dasa used a 90 mm exit nozzel with a maxx cone it worked realy good, whent too a 865 cc dasa and hade too change too a very small cone.

Sub

I was running similar setup hade a 85 exit nozzel and small cone, this was for freestyle.

Does footholds look Real nice what is the wedge/Heel stopper made of ?

If your pump tunnel is Big enough get 148 pump if not 144 mag, put that power too the water.

I used 3 mm aluminium

Hei Zane Build lookes good you got one hell off a deal, i was the one with orther maxx hull build from 2014. After seeing you build i have been scratching my head about the exhaust issues i hade. But after looking more closely att your pics it seemes your midshaft was mowed forwert, witch...

I have used camping mat for the tray Worked fine, but HT pad for the rest.

What cases ?

Saw this the orther day