Search results

Very nice!!did u get her wet yet...

Well it starts:confused:didn't like the turf so I had extra turf,since the old turf was coming off:D

Pick up a wb1 and so far from what I see is a 62t motor with a Coffman pipe and a auto switch bilge pump with a umi steering..my plans are????I don't know yet...but reading and seeing what u guy are doing with your blaster there alot u can do with this ski..but after my phantom build I am tap...

Ahhhhhh yes sinsay has watch over me too....haha.....he has gave me a lot off secret kung-fu move....lol.....

...Yeah,yeah....I got to admit it is a nice looking chin pad...u better I am up one on u...haha....

Getting closer,bet @Emily is getting excited,I know cause I could not go fast enough to get my parts installed to ride....

Well I bit the bullet,I was adjusting my steering to get get more throw and found out my steering cable was hitting the bracket on the chin pad so I went and purchase a Crazy Joe chin pad from @Jamo07sj...for all u oem chin pad hater....lol..... I took off the black turf install a blue turf to...

Black to match,but like red too

it was a long weekend breaking in my BB781 and while I doing the breaking in I was like thinking it felt like my 735cc with good pull..i was kind off disappointed it felt like this I was expecting to pull harder knowing it a BB781...BUT after 2 tank and following Jetmaniac's instruction to the...

Set the carbs to @JetManiac spec and this is what happen

Out with the old 735cc In with new BB781 @JetManiac Got all the new parts installed,test ride and breaking in the new motor this weekend....

I agree with above post,this hull is like 2 hull in one,it stable like a sxr,freestyle like a superjet,it dose what u want it to do.I am glad I went with @sinisterjosh209 phantom hull and I don't have any regrets going with this hull,plus installing all the parts was a breeze...it was a so easy...

Out with the 144mm solas pump In with the new 148mm h20 torrent sb pump

trying keep busy till parts get here Painted my motor mounts Replace all the bolt on the carbs and installed my extreem throttle knob adjuster Cut up my spare e-box cover and replace my connectors

That what I have on my carbs from j/m,I just had to trim the housing cause it was to close to t-adjuster which was hard to get my finger on it to adjust,I was looking at extreem throttle adjuster knobs and just remove the little bar for the t-adjuster

Thanks @Pablo my 735 motor is on it way to @JetManiac headquarter

Then replace the bolts on the intake mani and my stock f/a

I had a problems last season tryin to adjust the low and high needle so I trim off some of housing around the high and low Then I replace the bolts,clean & painted the 38's flat black Then I went and clean & painted the intake mani and replace the gaskets and made sure my vf2 are still...

Motor all box up and ready to ship @JetManiac tomorrow...can wait to get my hands on that BB781 While I have time before the BB781 get here I when ahead and bore out my factory B head and mani to 50mm Try to take some pic of how the head and mani match up,it look pretty good Left side...