Search results

Search did not turn up much regarding composite plates. Some fear they are weak and others say they are to much $$. My current setup is a 2013 SJ with Blowsion stainless intake grate, 144 12-vane pump, 10/16 Hooker, stock nozzle and cone. Stock plate with D-cut. Have ridden this setup two...

Haven't had it out on the water again. I'm sure you guys have seen the news of the flooding in south Ms. Will remount the tach to be visible while riding and up the jet size. If needed I will drop the compression some.

TTO tachs have done well on all of my machines so far. I use them on dirtbikes and ATV's with out issue. They are good enough to provide what is needed to set idle speeds and monitor changes in engine RPM. Updated original post with impeller information. I had to look that up from last season...

What negative experiences have you had with the Outerwear's? I have run them on my K&N filters on ATV's for years without issue. When I pull the hood I can see water droplets on the outside of the Outerwear's and the Flame Arrestors are dry. If it comes to it I will pull them off. I will be...

Going to check if I have 140's. If not I will get some coming to the house.

High and Low speed mixture screws are blocked off on your ski. This was an EPA compliance thing. You need pull the carbs off and removed the brass plugs. The plugs can be removed in many different ways. The stock mixture screws have a very shallow screw slot that will be easily damaged when...

More Details: Compression checked after head installation: 186/187 psi Set low speed speed jets and set idle strapped to the trailer Rode and checked wake-zone and mid-range fueling, checked head and pipe for temps multiple time. Checked compression during a plug swap and engine warm 185/185...

Oops how did I leave that out. Stock N&S 95g Spring don't remember pop off pressure

This was the first run after the pipe install. Tach is mounted under the hood where I can't see it while riding. (Need to extend the wire). I only made the two long WOT pulls. Put it on the trailer after the second time. To adjust for warm weather I would normally lean it out some on the needles.

My background: Experineced engine builder and mechnaic. Experience with any thing from a chain saw to turbo v8's. Issue: Super Jet sometime stalls during a long run at full throttle on flat water. Ski: 2013 SJ - Purchased new in 2013, Ride 4-8 hours per week, Use non-ethanol fuel with...

Updates?