Recent content by Wave ninja

Thicken epoxy for quick spot hold then 5200 the rest

This cable seems like it would work if you are fabricating. 116” in length.

ADA racing

⌨️EPP for me

Agreed straight axle rear, not sure if they are Controll arms in the rear now

I buy my step bits/uni bits from there, i have put them through 1/2 steel with a pilot

Same 1 strap allows for more aggressive riding on my sj,

Maybe grind the motor mount a little to make chamber clearance, i did not grind mine but will if i take the pipe back out. I also added another hose clamp right before the water box to take the hard bend out of the elbo. To adjust bottom screw i use a hex bit in a 1/4” box wrench. A set of Crows...

I needed to shorten exhaust manifold bolts a little (upper centers) got it all together and was leaking water, cut 3/16” off and wasn’t an issue anymore

Deleted

Might be a good fishing hook But wasn’t even in contact with the conductors.

Any motor mods or all oem? Has the ski ever been sunk Crimp new msd plug caps on? Solved it on my 2016

5.5 inch hole saw. Fast and clean. Drill from rough side of plate. 20mm ProTec nozzle. If you are bottoming your cable send a self tap screw in the stop until you change cable

2008 superjet I had put on t handle screws notice they are longer than the stock and the t will bottom out on the carb casting I understand most cut off the chunk of aluminum around the mixture screws which i will do Are the stock screws better?