Recent content by subhard

  1. subhard

    650/X-2 Steering Locked Up

    I had a steering cable break on my super chicken last year. Replaced it with a jet maniac new one, everything was good to go on the trailer. Finally just got around to launching it and the steering wheel immediately locked up to the right. It has a few degrees of play to the far right, but won’t...
  2. subhard

    WTB kawi 750 single carb intake small pin manifold

    looking for a small pin 750 kawi intake manifold for a single carb. Thanks!
  3. subhard

    FX-1 BOB on a Budget Buildup

    I think the ping pong compartment might be collecting water. Anybody have any good rear drain ideas? Worse case scenario I might put some SXR style drain(s) on it.
  4. subhard

    FX-1 BOB on a Budget Buildup

    I love this jet ski
  5. subhard

    FX-1 BOB on a Budget Buildup

    Anybody know why this ski might have a 2009 exhaust on it?
  6. subhard

    FX-1 BOB on a Budget Buildup

    Finished the ski! Can't wait to ride it
  7. subhard

    FX-1 BOB on a Budget Buildup

    Finished the intake, ride plate, steering, and the adjustable bold plates. It's 100% ready for turf now. I'm super thankful the 144 pump came with a pre-modified jet dynamics ride plate. Any FX1 plate would come nowhere near to fitting. This one has been mostly grounded completely away around...
  8. subhard

    FX-1 BOB on a Budget Buildup

    Anybody know what the tube on the right is? It comes out as this on the other side. I'm confused.
  9. subhard

    FX-1 BOB on a Budget Buildup

    the AM blowsion 144 pump "fits" right in but holy hell its tight. I ground the pump shoe out to about 140 I'd guess so it's close. And there's a stainless skat inside the pump.
  10. subhard

    FX-1 BOB on a Budget Buildup

    I also glassed in a pancake Pete front foothold. And after sanding this is what we ended up with. Tray all ready for turf as soon as I finish getting the 144 pump in.
  11. subhard

    FX-1 BOB on a Budget Buildup

    as you can see I needed to build out the top rear corners of the gunwhale bump to fit the plate in a proper position for the holds. I used fiberglass reinforced body resin stuff.
  12. subhard

    FX-1 BOB on a Budget Buildup

    we cut the slots needed for the bob plates
  13. subhard

    FX-1 BOB on a Budget Buildup

    So I just bought this ski off tanglebar after it sat in a shed unfinished and untouched for the last four years. I'm in the process of finishing it up now and will have it ready to go by May. Here are some updates.
  14. subhard

    spark problem need advice/ski dies after i swapped out whole electrical box?

    Anybody else have any idea on why it would be running so great but randomly and intermittently just dying? It starts right back up after and runs good again. Terminals are tight on the battery
Top Bottom