Recent content by strictlystandups

ohh the power!! muaahhhahahahah!!! wait... does it actually work? :scratchchin:

thanks for the info but I do not have an A/M pipe nor do I have dual cooling lines in the cylinder head (unfortunately). I have a completely stock system except for the extra cooling line installed in the pump which goes through the bulkhead below the bilge fitting(as shown in picture).

Some like it hot, not my engine though P.S. Tapatio is the hot sauce for people who actually like it hot. Cholula just doesnt have that fire!

well, there is no fitting going in the actual tail cone or "venturi" as they call it. There are only the lines going right into the pump housing aft of the impeller. Now as far as hooking them up to the motor, in regards to also hooking up the flush do I run the starboard line up to the...

I'm not sure if somebody did a dual cooling mod to the pump on my ski but it would appear that there are three lines coming outta the pump on the pressure side of it. The pump might be the old style that they put on the SN 650s. Also there is this awkward large hose coming out of the side (one...

I have one I could email but I think it might be for the RN's but there's not a whole lot that yami changed from what I noticed because I have an SN and have found useful info in there. except for cooling/fuel line diagrams (which I'll be posting on since I just reminded myself) so... how bout...

thanks man, your input is more than appreciated. I will start with a clean slate tomorrow. I def done my share of motors but this turf business is no effin joke.:dunce:

that's just it... I DO let it dry on both sides (like the can/directions say) and yet it touches and let's go like it were only tacky, not adhesive. Is there a small window of time to put the pieces together? I'll admit, I do engines, not turf. So now that i've given up for the night is there a...

Well, after I've already hacked up the tray turf job. I seemed to have done the same if not worse to the chinpad. Are you guys using the same stuff, the DAP Weldwood contact cement? I did exactly as the can says to the tee, and still it wont stick. Not to mention when I use the heat gun, it...

the price isn't as bad as I've seen but I'll only offer him maybe 1800. It doesnt matter what it is if has a bunch of hours on it than it's still used goods.

I wrote that last one right when I was doing it and I was very frustrated at the time. Well I made it look a little bit better, and now I know what to do and not to do the next time. I guess that's why they say there's first time for everything. Sorry for draggin this post on for so long...

http://www.xmetalworks.com/installation.php, try here first. I recommend moving your waterbox and possibly purchasing a new aftermarket one depending on your cash flow.... good luck

:aargh4:crap!!!! I totally :-):-):-)kkkkkkkkeddddd the right side up. Damn I'm a noob!! as you may notice at the top of the pic there is a bump that I couldn't get to sit down without looking sheity and I cut too much of the side before I glued it so I hacked in a piece. any suggestions on...

right man thanks a bunch! I going to attempt all that this morning. wish me luck!

well unfortunately I broke down and bought one today (at harbor freight) and also unfortunately it wasn't on sale (19.99). however. i dont care as long as I get the turf on correctly. tomorrow it should be on and then I'll post my pics that no one will look at or care about HA! :chairfall: