Storbeck's latest activity
-
SCouldn’t help myself had to put the pole on and look :)
-
SStorbeck replied to the thread Sport port templates .I've never used the sport port templates, but I've used the Yamanube template on a 760. The stock port timing on a 760 is a little...
-
SStorbeck reacted to kevbo's post in the thread Carburetor (specs) Database: SuperJet and Blaster 1 with
Like.
The most accurate advise on jetting? Whats in my carbs probably won't work in yours. Learn how to tune! -
SStorbeck replied to the thread New Inverse Hull.Looks awesome!
-
SFinally got the new ski done and got a chance to take it for a rip. Im really happy with the changes. Grips corners a little harder...
-
SStorbeck replied to the thread Who does high quality Aluminum repair?.Is there room to simply drill the holes deeper at the original thread size? At least in the middle hole positions, then put a thread...
-
SStorbeck reacted to waxhead's post in the thread 760 swap runs amazing, but the throttle is idle or rip your arms off. with Like.
That's pretty good information. I treat the low speed as the everything jet. from there I trim with the high speed up top. We tune very...
-
SStorbeck reacted to DylanS's post in the thread 760 swap runs amazing, but the throttle is idle or rip your arms off. with Like.
A well tuned 2 stroke pipe produces a supercharging effect at a desired RMP range that can be felt by the rider and increases horsepower...
-
SStorbeck replied to the thread Who does high quality Aluminum repair?.I would be looking into larger thread inserts due to concerns about welding affecting the temper of the aluminum, plus damaging the...
-
SI lower the pipes water pressure with a pisser between headpipe and stinger, which also has a 1/8" restriction. I can tell how much...
-
SStorbeck replied to the thread Wax header pipe.I'm on board but I like the ability to adjust .050 is kinda big
-
SI would have been happy to have removed all the screws and left the bottom hole only
-
SStorbeck replied to the thread Wax header pipe.I like the 6mm screws, if they have a 10mm nut and t handles or a 10mm head to match the wrench I'll probably already have handy that...
-
SIf you're running it as a dry pipe there really isn't much tuning besides at the stinger for the water box. The stinger has a jet in it...
-
SStorbeck replied to the thread Bendix Engages, Spins Engine 1-2 Revolutions, then Disengages and just Spins Starter ?.Can you share how you inspect a bendex?