Recent content by scott3708

Jump it like this removes limiter

Did some work with this and tried the variable pot with the 50k 1/4 watt resistor and 50k trim pot. But its a pain to keep opening for a adjustment, so with a tach a 87K resistor was 6960rpm, 80K resistor limits to 7200 rpm, a 75.4 K ohm limits at 7440 rpm. Your not going to find the exact...

If its a small seperation can you inject sealant? Ive done one with a rubber urethane I got from the auto parts store and it sealed it like new. It was a 3M product got it at Advance Auto ...

Ya jugs luv em !!!!

Are you sure you put the fuel lines on right? SKI Till I Die is right Spark first make sure you got it, Then fuel,

Check out the Hottie album! Tasteful yet refined!!!

Denise Milani HHOTTT huh

Got a Good pipe? Good compression on 2nd 650 150 psi good main bearings and seals.... allrightyy thenn? Pipe, and jet carb per exhaust manufacture. Will give a nice upgrade then maybe upgrade prop, MSD enhancer or A head replacement with 30cc domes will boost you to 180-185 psi on stock motor no...

All you really need to do is move the engine up towards the front 3-4 inches that usually means removing front exhaust hose and the engine mounting bolts and the battery. The trick is remembering what shims come out of what corner and to put them back respectively. Then after you scoot the...

Yes when they start growling it usually means the bearing is going bad grease will quiet it if its dry and it may last the season just keep an eye on it for leaking water or excess vibration. The mid bearing is under driveshaft cover and the cover clips into a rubber tab that is mounted on the...

Well after talking with the factory and taking it all apart the bearing when installed someone when pressing it in collapsed the side dirt seal (on the bearing itself) binding it up. They are sending a new one no charge, in the mean time we pressed out the old bearing and drove to the auto parts...

:banghead: Help I have a 92 SJ650 and I replaced the intermediate bearing housing as my last was totally shot and grinding. Now the new bearing installed, shimmed and after 15 minutes of light breaking in the rebuilt engine the intermediate shaft is so hot it sizzles. Removed the engine and ran...