Recent content by mk1

☹️

Replacing the mid shaft/intermediate shaft housing on my FX1, can this be done without removing the engine, or is it a must…? Thanks in advance guys….

Hello guys, the standard steering on my Fx1 is either too loose or too tight, Can I buy new steering washers, and if so where do I purchase same, thanks in advance…

Cody, it’s fitted with a boowsion 144mm pump and a b-pipe exhaust with an after market waterbox.

I have a blowsion 144mm pump and a b-pipe exhaust with an after market water box fitted....

Hello, i am about to fit duel cooling to my Fx1 with a 760 motor, twin carbs, 144 pump, b pipe and after market waterbox. I have tapped into the jet pump, using the factory syphon tubing, but need advice on to where tap the other end to the exhaust, Also I am installing a flow control valve...

Thanks, I’m gonna grease it up and see if that helps....

I purchased the ski a couple of years ago, and have not been working on the shaft, there were no problems until recently...

Please excuse my spelling “ enquiry “ lol

Hi guys, i am taking in water when my ski is parked up on the slipway, and I’m pretty sure it’s getting in tru the drive shaft seal, are these seals stand alone or are they part of the drive shaft bearings..? Thanks in advance....

Hi, I heated the tank and kept rolling it with a baseball bat as much as I dared safe as I could see that the thickness of the tank was been compromised, it did create the spacing that I needed , so far so good...

yeah, the chicks can really cramp a dudes style.... !

Hello guys, is the Fx1 steering cable unique or are the superjet steering cables the same ...? Thanks in advance...

Yes, it seems idiot proof... I will keep you posted...