Recent content by LegDragger64

Ok I had read the description that mentioned a brace so I was curious Thanks for the info

Novi brace included ?

Did you find a prop Got a 15/18 big hub swirl here

Got an SXR 800 Fac pipe manifold here

Factory Pipe exhaust manifold from an SXR 800 wet pipe kit Manifold only 325 shipped

Those settings on the screenshot were not entered by me its what comes up on the screen when first opening the software I have installed and programmed quite a few of these , but was getting the error message when clicking on read this time With a previous zeel install , I got the error...

Got it to read. All good now Thanks

Those settings are just the blank screen New zeel hooked up for first time Trying to read what’s programmed into it so I can make some changes

Anyone had this error message when reading maps ? Error , some data points exceed limits

225 each

Got 3 Skat Trak 148mm Props All 3 are thin blades with impros race finish. 13-18 13-19 14-19 250 shipped each All 3 for 700 shipped

Hate I will have to miss this race event due to just having back surgery. It was a blast last year. Surf races are always a blast. Lots of scenery.

Yes that should be repaired with epoxy to get a good base gasket seal , however you need to look elsewhere for the cause of runaway condition because a base gasket leak will not do it .

This is my 3rd year using TS2 ignition and it has been bullet proof. Never experienced any hard starting or kickback. So good that I put one on a 2nd SJ.

I use box end wrenches on the prop / shaft tools. No open end wrenches or the will slip. And most often have to stand on the pipe to get it to go. Give it a bounce with full weight. M20 LH die to clean up the shaft threads.