Recent content by kawi kid

How did your rail caps line up? My Jettrim caps are way off on the rear tabs and the rivet holes are no where near close

Well I finally got the SOB off! Apparently after drilling out the rivet I only punched out the very center of the rivet and the outer portion was still holding it on. The carbon deposits hid it well so I didn't see that there was still some there. Thanks for the help guys!

That's what ive been trying to do for the last week. But when the flange is twisted or pryed it pulls the entire exhaust tube with it and is breaking the seal in the firewall.

I know its serrate because TMB sells a replacement low profile one. I know it comes out i just have to figure out how. If i had known how difficult it was i would have taped it off but I've already cut all of the gasket away so now i have to get it off to replace it

Apparentl the X doesn't have the ability to upload pics rom the computer so thats not an option.

If anyone could provide me with some quick input i would appreciate it! Im trig to drop my ski off to paint today and this is the last thing holding me up! Ive tried for hours to remove the OEM exhaust bezel and can't get it off. Ive cut through all of the silicon and gasket that sealed it to...

Well the NRS gloves look pretty bulky, I think Ill give the psycho gloves a shot!

Well I don't think we've got a single day below 70 so far so pretty warm. But like I said im a baby!

Haha that's hilarious, we Arizona boys are used to 110 degree heat so I don't do well with the cold water! Any info on those gloves? what are they and how thick?

What are you guys using for gloves in cold water? Im in AZ but im a baby when it comes to cold water and the Jet Pilot gloves I bought are thinner than the MX gloves I wear! Any suggestions?

What color blue is that? Looking to do something similar

Well after riding a few times and trying to switch my stance ive realized that my lack of balance and coordination from my spinal cord injury isn't going to allow me to get good at switching anytime soon. Looks like I will be riding regular for next season.

could you elaborate why?

Exactly what i was looking for. Thanks for the quick answer! Debating about sponsons, just can't make up my mind if between bolt through like blowsion or screw on like Prowatercraft

I plan on doing a Jettrim mat kit with rail caps on my SXR and am trying to find the replacement bumpers people are using like on this ski: http://www.pwctoday.com/showthread.php?t=374473 Ive seen it done on quite a few boats but cant seem to find where they get it from. Could anyone point me...