Recent content by jadrian

Awesome thanks.

Does anyone know what kind of glue can be used to install a new pump shoe? The old factory glue looks pretty thick, and gets a little soft when heated. Thanks

Yea the previous owner took care of the stock bilge. Not sure why.

Thanks man. Going to replace the shoe first and test it out. If it still runs like crap then I'll hit you up.

Alright thanks. I might just chisel that intake guide out and glue a new one in. Do you know what type of glue to use on that? And for the prop clearance do you check that with a :-):-):-):-):-):-) gauge or something else?

Anyone have any tricks to seal that space? Was thinking maybe spray foam the big gap, cut it down then epoxy over it?

Wow, that sounds totally lame. Guess that's why it's' not on there. You think I would gain any thrust taking that nozzle off and grinding the bilge port off and filling those two holes?

Bought an FX-1 this season. I noticed that port off the left side of the pump doesn't have anything on it. Was there supposed to be a hose or something connected to it? The engine water intake is behind it a few inches. The bilge tube is on the right side and it's blocked off inside the...

So I'm wrenching on a buddy's wave runner. It's a kawi st750. The ski runs fine cold but when it's warm it cavitates. It's done this on about 10 different occasions on different bodies of water. I started looking at the pump and the plastic intake guide that runs water into the pump is all...