Recent content by demian5

  1. demian5

    SX/SXi/SXi Pro My first SX

    What are the last two numbers of the HID on the Right Rear? 92 93 or 94?
  2. demian5

    SX/SXi/SXi Pro Found an old SXI.

    Then buy my ski. Pictures are located here... http://www.x-h2o.com/threads/114687-1994-750SX-stock-low-hours-been-sitting
  3. demian5

    SX/SXi/SXi Pro Found an old SXI.

    No, I'd get another older 2 seater 2-stroke. The 4-strokes are cool, but I'd rather spend that coin on my car.
  4. demian5

    SX/SXi/SXi Pro Found an old SXI.

    Fire it up before you put too much $$ into it. I got a 1994SX in worse condition and it runs flawlwssly with a bench no-part carb rebuild and new plugs! You are golden. Mine ran great first time out this fathers day. However with it being so much work (as well as shin bone shenannigans) it...
  5. demian5

    SX/SXi/SXi Pro First Stand-Up Ski What to do to get it going.

    You NEED to put a "T" at the hose on top of the head so you can hook up a water hose to run it on the trailer. DO NOT RUN IT LONGER THAN 10-15 SECONDS WITHOUT WATER TO PREVENT DAMAGE! When you get the ability to hook up a garden hose: 1. Start the ski, run for maybe 10 seconds. 2. Turn the water...
  6. demian5

    SX/SXi/SXi Pro 1994 750sx Dead Mans Switch

    I bought one and put it on. It works.
  7. demian5

    SX/SXi/SXi Pro 1994 750sx Dead Mans Switch

    Why yes Demian, this is the correct part number for the replacement switch plate.
  8. demian5

    SX/SXi/SXi Pro First Stand-Up Ski What to do to get it going.

    I have a 1994 750SX in about the same time of sitting. I did a bench rebuild of the carb without replacing any parts. It runs good and idles great. I just got a replacement lanyard switch plate (buttons only) from Kawasaki for $50. It is NOT listed as a replacement for that ski. Part...
  9. demian5

    SX/SXi/SXi Pro 750SX Replacement Hood Seal - Running Out of TIME!!!

    Hey guys - I plan on taking the skis out for the first time on father's day. My hood seal on my 1994 750SX is in bad shape. What is easily found that I can replace it with? Thanks!!!
  10. demian5

    SX/SXi/SXi Pro 1994 750sx Dead Mans Switch

    To convert from the stock to a dead mans switch only requires this switch plate from a 1995 SXi right? 32099C CASE, FR, SWITCH 32099-3809
  11. demian5

    SX/SXi/SXi Pro 750SX Bilge Pump Installation / Recommendation

    I think I should install a bilge in my ski for safety reasons. Can someone point me to a post that they know of or site to buy and install the pump myself? Thanks!:reporter:
  12. demian5

    SX/SXi/SXi Pro 1994 750SX Plugs really clean, look a little too wet

    I bought NGK for both skis last night and installed new NGK boots (had the oe Blue ones on there). I'm bgonna drain the oil and put in some fresh Kawasaki 2 stroke oil as well. Yes I get a popping on decell on the 750SX but not on my 750 SS XI.
  13. demian5

    SX/SXi/SXi Pro 1994 750SX Plugs really clean, look a little too wet

    I have had my ski up and running (trailer only) for a couple weeks and have ran it maybe 20 minutes (with water attached of course). My son in law who is more familiar with two strokes mentioned to me that it seems to "ping" a bit on decell after revving up. We pulled the plugs and he said they...
  14. demian5

    SX/SXi/SXi Pro The best 750 carb.

    I have a set of duals from a 1994 750 ss xi I was thinking of piutting on my 1994sx. Are there any issues with that? I have the manifold, spark arrester, the whole nine yards...
Top Bottom