Recent content by Chris024

Thanks for all the tips and help everyone! Ended up doing 3 layers of 8oz, thickened epoxy in the bond line, and ground out/filled with thickened epoxy on the outside. I think it turned out not bad but time will tell lol. I hadn't heard of peel ply, good tip for next time but had to get it done...

Yes, pulling the pipe now, do you think i can just leave the ouside alone? don't want to worry about paint/gelcoat so i'm hoping to just do the inside well and call it good

Got a crack in my hull in a awkward spot, how should I repair this? Do I have to fiberglass on the outside? There's an old glass repair just below this spot, can I get into the seam well enough to repair this from the inside? Never done fiberglass before but figured this should be doable.

Just sent ya a dm

Anyone got a fuel door for a Squarenose they'd sell? The surf stole mine last week :(

Did you just find that one clip or do you have a book/PDF with all kinds of diagnostic specs?

Oh sweet, thanks

Ok cool, any way to test it? Or just replace it?

Ok yeah that's good info, when it dies it's pretty instant. Also just replaced the start stop switch with OEM. I've also been reading about coils. Could it be a coil going bad?

I'm having an issue with my '91 SN 650 where it will randomly cut out completely, usually it will start right back up, but a couple times it has gone into a limp mode where the engine sounded fine but would bog at 1/2 throttle. Shut it off and let it sit, then it was fine. Richened it up just in...

Nevermind, I tried the jumper just now and it doesn't work anymore, just some clicks

I ran the original battery and jumped it with a little jumper box, and it started up fine

Just bought a ETX16L from AutoZone. Threw it in my 650SN, just clicking as if it's dead/low. Voltage was at 12.3 so I threw it on a battery charger, voltage is at 13, still just clicks. The battery coming out of it was a ES16CLB, which is lead acid, ETX is an agm battery. I just don't...

Oh man no way that would be awesome! I'll shoot you a pm. Thanks a ton

an adjustment screw or a carb?